High-performance duct fan coil units KITANO of the Hino II series is an effective solution for air conditioning of large premises. Hino II high-pressure centrifugal fans deliver treated air to work areas through a complex duct system. It is especially important for rooms of the hall type such as conference rooms, supermarkets or rooms with a complex configuration.

Increased performance and efficient filtration system ensures high quality air treatment. Hino II high-pressure fan coil units are designed for operation in chilled water conditioning systems and provide for their concealed installation. It can be installed behind a suspended ceiling or in a room that is located away from the working area.

Standard Package

Body
The outer casing is made of high quality galvanized steel with a thickness of 1 mm. Mounts of the heat exchanger and the base of the engine are made of steel with a thickness of 1 mm. Its ensures maximum rigidity and reliability of the design.

Heat exchanger
It is made by a seamless method from a drawn copper tube equipped with aluminium fins and an anti-corrosion coating.

Gauge manifold
High-quality brass manifolds have a special design for lowering the hydraulic resistance. The air vent is built in as standard at the factory.

Fan
Low-noise centrifugal fans with forward-curved blades are characterized by increased pressure.

Motor
The motor uses four-speed asynchronous motors. They are distinguished by optimal efficiency, high power factor and energy savings. Also, this type of engine is the most reliable and easy to operate.

Plenum with filter
The standard filter is made of washable synthetic polypropylene 3–5 mm thick with an aluminum frame. In powerful models, double filters are used to improve the quality of cleaning. The filter is easily removed from the bottom of the unit.

Drain pan
Standard drain pan is made of high carbon steel without welding. It prevents corrosion and is provided with 5 mm thick insulation.

Extensive management
Fan coils of the Hino II series can be adjusted by thermostat HR107 or HR2008 (purchased separately with relay for switching with the fan motor).
All Hino II fan coil units can be equipped with a control panel. It expands the possibilities of regulation, it allows you to connect the fan coil units to a single control panel (up to 64 units) and to the building dispatch systems. (Optional)

Optional equipment

3 way valve
Actuator to valve
Wall-mounted remote control with LCD screen
Wall thermostat
Control Panel
Group control console
Gateway to connect the dispatch system

Work range

Incoming water temperature
Cooling mode
3 ~ 20 ˚C
Heating mode
30 ~ 80 C

Air temperature
Cooling mode
17 ~ 32 С
Heating mode
0 ~ 30 C